Scottsbluff Auto Repair

Vehicle emission testing has become ubiquitous in North America and for a good reason.  Clean air quality is important for the environment and all of us.  Since vehicle emissions are among the main causes of air pollution, emission testing can alert you to problems in your vehicle than can be fixed so it won't needlessly pollute. Emissions tests are looking for certain toxic gases internal combustion engines produce, such as nitrogen oxide, particulate matter, non-methane organic gases and formaldehyde.  Emissions control systems reduce these gases if they are working properly.  The best way to minimize pollution is to keep those vehicle systems working properly, and periodic inspection and maintenance is the key.  So if you want to make sure your vehicle will pass an emissions test, it helps to know what might go wrong. Let's start on the easy one.  Your gas cap could be loose, allowing vapors to escape into the atmosphere.  The most common solution ... read more

  Welcome to the Twin City Auto automotive blog. Today, let's talk about the effect of tire wear. Let's focus on stopping in wet Scottsbluff conditions. In order for a tire to have good contact with the road, it has to move the water out of the way. If it can't move the water, the tire will actually ride on top of a thin film of water.That's called hydroplaning. If it's really bad, Scottsbluff drivers can actually spin out of control - endangering themselves and the other drivers around them. At best, you won't stop as fast. So how does a tire move water? It has channels for water to flow through. Look at your vehicle tire and you'll see channels: channels that run around the tire and channels that flow across the tire. They're designed to direct water away from the tire so it can contact the road better.And the deeper the channel, the more water it can move. A brand new Twin City Auto tire has very deep channels and can easily move a lot of water ... read more

If you’ve noticed your vehicle is hard to start, stalling, or has lost power, the culprit may be a part with an odd name: the MAF sensor.  You may have never even heard of a MAF sensor, but it’s important that it be working correctly, or you may be experiencing some fairly significant engine issues. All vehicles bring in air and direct it through an air filter before it goes into your engine, where it mixes with fuel to provide power to get you going. There’s a tube-like device with a sensor inside it that measures how much of that mass of air is passing through. That’s why it’s called a mass air flow sensor, or MAF sensor.  If the MAF sensor isn’t working right, the engine’s computer can’t figure out the right amount of fuel to mix with it, and your engine may hesitate or stall.  Sometimes this will cause your Check Engine Light to come on, and any time it does that, make sure you have your vehicle checked by a professiona ... read more

Some problems are easy to diagnose on a vehicle; others aren't.  Figuring out what's wrong with a malfunctioning turn signal sometimes fits into both categories.  By the way, if your tempted to just leave your broken blinker broken, remember you can get a ticket for not using them, not to mention you are missing a great chance to communicate your intentions to other drivers on the road. There can be lots of signals that your signals are on the blink.  Does only the driver's side signal not work or the passenger's side? Do your hazard signals work? Do the lights illuminate but not flash? Can you see the indicators on the dash blinking? Do your turn signals turn off after you've finished your turn or do they stay on?  These are all great clues for the technician. Here's one common symptom to take note of.  Your signal all of a sudden starts blinking much more quickly than it used to.  It could be a simple as a burned out bulb.  But there are many differ ... read more